Teknamotor Skorpion 160 R/90 Holzhäcksler Häcksler Chipper

Skorpion 160 R/90 is designed for shredding tree limbs and trunks with a diameter of up to 160 mm. Weight 850 [kg] Branch diameter 160 [mm] No of knives 2 cutting + 2 counter-knife Feeding speed up to 33 [running meters/min] Chipping capacity up to 12 [stère meters/h] Chip width from 9 to 11 [mm] Feeding unit hydraulic feeder Disk diameter 550 [mm] Hopper dimensions (WxH) 285 x 165 [mm] Type of drive tractor’s PTO Min. power of tractor 80 [hp] ()* - dimension after erection of the pipe, during operation Equipment included: -PTO shaft -Independent hydraulic system -Adjustment of height of ejecting the chips -Rotary chimney 360° -No-stress system Additional accessories on request: -Extension of the ejection tube

Skorpion 160 R/90 is designed for shredding tree limbs and trunks with a diameter of up to 160 mm. Skorpion 160 R/90 is a disc model with a pneumatic blow-out system on the disc. Chips are ejected through the rotating chimney which can turn by 360 degrees in relation to the chassis. The cutting system consists of a disc with cutting knives sharpened on either side. The chipper has a three-point suspension system and is designed to work with an above 80 hp farm tractor. Innovative solution of the lateral position of the inlet hopper enables simultaneous transport of chipper and trailer with a tractor. The essential equipment of the chipper includes a hydraulic propulsion system servicing the feeding rollers driven by its own hydraulic pump. There is also a possibility of equipping the chipper with a unit for receiving the hydraulics from the tractor. Standard models also have a lever system of the hydraulic divider that can change the direction of the feeding rollers. The chipper is also additionally equipped with an electronic system of work control, protecting the machine against excessive duty through temporary stopping the feeding. Overall dimensions (LxWxH) 1450 x 1890 (2390)* x 2150 (2450)* [mm] Weight 850 [kg] Branch diameter 160 [mm] No of knives 2 cutting + 2 counter-knife Feeding speed up to 33 [running meters/min] Chipping capacity up to 12 [stère meters/h] Chip width from 9 to 11 [mm] Feeding unit hydraulic feeder Disk diameter 550 [mm] Hopper dimensions (WxH) 285 x 165 [mm] Type of drive tractor’s PTO Min. power of tractor 80 [hp] ()* - dimension after erection of the pipe, during operation Equipment included: -PTO shaft -Independent hydraulic system -Adjustment of height of ejecting the chips -Rotary chimney 360° -No-stress system Additional accessories on request: -Extension of the ejection tube